Design and Simulation of Cutting Optimization and Controller for the Diamond Multi-Wire Sawing System

摘要:

文章预览

The purpose of this paper is to investigate the effect of ablation parameters on the ablation characteristics for the fixed diamond multi-wire sawing by using Taguchi method. Meanwhile, using the optimal ablation parameters, we accomplish the cutting dynamic analysis and controller design of the diamond multi-wire sawing system. In this paper, we apply the Chemical Mechanical Polishing (CMP) theorem to derive the ingot profile and cutting rate equations of the diamond multi-wire sawing system. The characteristics discussed in this paper include ingot profile variance, cutting rate. The ablation parameters are tension force, wire velocity, cutting force, width of the kerf. The orthogonal array, signal-to-noise (S/N) ratio and analysis of variance (ANOVA) are employed to analyze the effect of these ablation parameters. In the meantime, we use the optimal ablation parameters to accomplish the controller design of the diamond multi-wire sawing system, include diamond high-speed control of the main roller in the cutting system, cutting rate control and the moving wire bow angle holding.

信息:

期刊:

编辑:

Qi Luo

页数:

2331-2337

引用:

C. C. Peng et al., "Design and Simulation of Cutting Optimization and Controller for the Diamond Multi-Wire Sawing System", Applied Mechanics and Materials, Vols. 58-60, pp. 2331-2337, 2011

上线时间:

June 2011

输出:

价格:

$38.00

[1] Thomas Palathra, Raymond Adomaitis, Process Modeling of a Wire Saw Operation, The Institute for Systems Research, (2008).

[2] W.I. Clark, A.J. Shih, C.W. Hardin, R.L. Lemaster and S.B. McSpadden, Fixed AbrasiveDiamond Wire Machining—part I: Process Monitoring and Wire Tension Force, International Journal of Machine Tools & Manufacture, (2003).

DOI: https://doi.org/10.1016/s0890-6955(02)00215-8

[3] William I. Clark, Albert J. Shih, Richard L. Lemaster and Samuel B. McSpadden, Fixed Abrasive Diamond Wire Machining—part II: Experiment Design and Results, International Journal of Machine Tools & Manufacture, (2003).

DOI: https://doi.org/10.1016/s0890-6955(02)00216-x

[4] Zhang Yibing, Dai Yuxing, Yuan Julong and Xiong Wanli, Design and Implement of Wire Tension Control System for Multi-Wire Saw, Journal of Mechanical Engineering, (2009).

DOI: https://doi.org/10.3901/jme.2009.05.295

[5] Madhav S. Phadke , Quality Engineering Using Robust Design, Prentice Hall, Englewood Cliffs, (1989).