Reconstruction of Impact Loads within Fibre Reinforced Polymers

摘要:

文章预览

Fibre reinforced polymers (FRP) offer a high potential to reduce kinetic energy. As a consequence of this, fibre reinforced polymers often have a higher risk of being exposed to impact loads. The knowledge of the mechanisms and of the material loading during and shortly after an impact load is essential for an ‘impact-load-monitoring-system’ to predict possible structural failures. Especially a prognosis of structural failures caused by – often unrecognized - barely visible impacts is an important factor. Primary impact damages often leads to a sudden structural failure. These unheralded failures seems to be one of the most important problems in product development for the aircraft industry. By measuring the structural response at several discrete measurement points an impact can be detected, reconstructed and also rated.

信息:

编辑:

J. Quinta da Fonseca

页数:

209-215

引用:

C.R. Koenig et al., "Reconstruction of Impact Loads within Fibre Reinforced Polymers", Applied Mechanics and Materials, Vols. 7-8, pp. 209-215, 2007

上线时间:

August 2007

输出:

价格:

$38.00

[1] Koenig, C.R., Mueller, D.H. et al.: Visualization and Simulation of Flexural Wave Propagation within Fibre-Reinforced Polymers, SEM Annual Conference, St. Louis, USA, (2006).

[2] Koenig, C.R., Mueller, D.H. et al.: Fibre-reinforced Polymers under Impact load, Key Engineering Materials Vols 326-328 (2006) pp.1563-1568, Trans Tech Publications LTD, Switzerland, (2006).

DOI: https://doi.org/10.4028/www.scientific.net/kem.326-328.1563

[3] Prosser, W.: The Propagation Characteristics of Plate Modes of Acoustic Emission Waves in Thin Aluminum Plates and Thin Graphite/Epoxy Composite Plates and Tubes, NASA Technical Memorandum 104187 (1991).

DOI: https://doi.org/10.1121/1.404149