Evolution of Surface Morphology in Ni(γ)/Ni3Al(γ´) Two-Phase Foil during Electrochemical Etching

摘要:

文章预览

Evolution of surface morphology in Ni(γ)/Ni3Al(γ´) two-phase foil of binary Ni-18 at.%Al was examined during the electrochemically selective etching in the electrolyte of distilled water including 1 wt.% (NH4)2SO4 and 1 wt.% citric acid. In the early stage (0.5 h), only the γ matrix was etched and the outmost γ´ particles were protected by a preexisting surface product. As the γ matrix was etched more, the side surfaces of the outmost γ´ particles and the γ´ particles that were located inside were exposed in the electrolyte. They were dissolved, and had a high density of fine dimples. However, the dissolution rate of the γ´ particles was slower than that of the γ matrix and thus the selective etching was retained in this stage. Finally, at 5h, more γ´ particles were exposed and the flat and smooth surfaces of the outmost γ´ particles were completely eliminated by the dissolution on the side surfaces. From these observations plus the saturation of the current density observed in the electrochemical test, we concluded that the change in the surface morphology was finished at this stage. Thus, the surface became more rough and irregular, which resulted from the original two-phase microstructure and the fine dimple structure by transpassivation.

信息:

期刊:

编辑:

T. Chandra, N. Wanderka, W. Reimers , M. Ionescu

页数:

331-336

引用:

H. Y. Lee et al., "Evolution of Surface Morphology in Ni(γ)/Ni3Al(γ´) Two-Phase Foil during Electrochemical Etching", Advanced Materials Research, Vols. 89-91, pp. 331-336, 2010

上线时间:

January 2010

输出:

[1] N.S. Stoloff, Int. Mater. Rev. Vol. 34 (1989) p.153.

[2] Y. Xu, S. Kameoka, K. Kishida, M. Demura, A.P. Tsai and T. Hirano, Mater. Trans. Vol. 45 (2004), p.3177.

[3] D.H. Chun, Y. Xu, M. Demura, K. Kishida, M.H. Oh, T. Hirano and D.M. Wee, Catal. Lett. Vol. 106 (2006), p.71.

[4] D.H. Chun, Y. Xu, M. Demura, K. Kishida, D.M. Wee and T. Hirano, J. Catal. Vol. 243 (2006), p.99.

[5] Y. Ma, Y. Xu, M. Demura, D.H. Chun, G. Xie and T. Hirano, Catal. Lett. Vol. 112 (2006), p.31.

[6] M. Demura, Y. Suga, O. Umezawa, E.P. George and T. Hirano, Intermetallics Vol. 9 (2001), p.157.

[7] M. Demura, K. Kishida, Y. Suga and T. Hirano, Metall. Mater. Trans. A Vol. 33A (2002), p.2607.

[8] M. Demura, K. Kishida, Y. Suga, M. Takanashi and T. Hirano, Scrip. Mater. Vol. 47 (2002), p.267.

[9] M. Nakamura, M. Demura, Y. Xu and T. Hirano, MRS proc. 0980-II05-30 (2006).

[10] M. Demura, S. Hata, K. Kishida, Y. Xu and T. Hirano, Unpublished work.

[11] H. Borodians'ka, M. Demura, K. Kishida and T. Hirano, Intermetallics Vol. 10 (2002), p.255.

[12] D. Li, K. Kishida, M. Demura and T. Hirano, Intermetallics Vol. 16 (2008), p.1317.

[13] D. Mukherji, G. Pigozzi, F. Schmitz, O. Nath, J. Rosler and G. Kostorz, Nanotechnology Vol. 16 (2005), p.2176.

DOI: https://doi.org/10.1088/0957-4484/16/10/034

[14] H.Y. Lee, M. Demura, Y. Xu, D.M. Wee and T. Hirano, MRS proc. 1128-U05-35 (2008).

[15] D.A. Jones, Principles and prevention of corrosion (Prentice Hall, USA 1996) pp.116-122.

[16] G. Ertl, H. Knozinger and J. Weitkamp, Preparation of solid catalysts (WILEY-VCH, Germany 1999) pp.28-43.

[17] H.Y. Lee, M. Demura, Y. Xu, D.M. Wee and T. Hirano, Unpublished work.

从Crossref获取数据。
这可能需要一些时间来加载。