Effect of Repeated Quenching Heat Treatment on Microstructure and Dry Sliding Wear Behavior of Low Carbon PM Steel

摘要:

文章预览

The effect of repeated quenching heat treatment on microstructure and dry sliding wear behavior of low carbon PM steel was investigated. For this purpose, atomized iron powder was mixed with 0.3 % graphite and 1 % Ni powders. The mixed powders were cold pressed and sintered at 1200°C for 30 min under pure Ar gas atmosphere. Some of the sintered specimens were intercritically annealed at 760°C and quenched in water (single quenching). The other sintered specimens were first fully austenized at 890°C and water quenched. These specimens were then intercritically annealed at 760°C and re-quenched in water. The martensite volume fraction in the double quenched specimens was higher than that of the single quenched specimen. Wear tests were carried out on the single and double quenched specimens under dry sliding wear condition using a pin-on-disk type machine at constant load and speed. The experimental results showed that the wear coefficient effectively decreased in the double quenched specimen.

信息:

期刊:

编辑:

Duk Yong Yoon, Suk-Joong L. Kang, Kwang Yong Eun and Yong-Seog Kim

页数:

673-676

DOI:

10.4028/www.scientific.net/MSF.534-536.673

引用:

A. Güral et al., "Effect of Repeated Quenching Heat Treatment on Microstructure and Dry Sliding Wear Behavior of Low Carbon PM Steel", Materials Science Forum, Vols. 534-536, pp. 673-676, 2007

上线时间:

January 2007

输出:

价格:

$38.00

[1] N. Antón, et al.: J. Mater. Proc. Tech. Vol. 143 (2003), p.475.

[2] A. Simchi and H. Danninger: Powder Metallurgy 2004 Vol. 47(1) (2004), p.73.

[3] K.V. Sudhakar, P. Sampathkumaran, and E.S. Dwarakadasa: Wear Vol. 342 (2000), p.207.

[4] S. Tekeli and A. Güral, in: Twelve International Conference on Composites/Nano Engineering, ICCE-12, Teneerife/Spain, 1-6 August: (2005).

[5] L. Ceschini, et al.: Tribology International Vol. 39 (2006), p.748.

[6] M. Aksoy, M.B. Karamış, M.B. and E. Evin: Wear Vol. 193 (1996), p.248.

[7] A. Bayram, A. and A. Uğuz: Mat. -wiss. U. Werkstoffech Vol. 32 (2001), p.249.

[8] H. Zhang, and R.M. German: Metal Powder Report, (2001), p.18.

[9] A. Güral, S. Tekeli and M. Gürü, in: EURO PM2005, Conf. Proc., Prague, Vol. 1 (2005), p.175.

[10] A. Bayram, A. Uğuz and M. Ula: Materials Characterization, Vol. 43 (1999), p.259.

[11] J. Wang and H. Danninger: Wear, Vol. 222 (1998), p.49.

为了查看相关信息, 需 Login.