Micro Metal Injection Molding Process for High Performance Titanium Alloy

摘要:

文章预览

In this study, gas nitriding was processed for various sizes of Ti specimens which were produced by metal injection molding (MIM) process, for the sake of enabling the high functionality at low processing cost. It was shown by the nitriding treatment that the hardness of the surface increased extremely and the microstructure changed to the TiN and acicular α-Ti phase. With respect to the effect of the nitriding on the size of parts, micro dumbbell specimen had around five times higher content of nitrogen than the block ones. It was suggested that the size of μ-MIM products is so small that the surface treatment can contribute significantly to improve the properties, and then gas nitriding process may be one of effective surface treatment methods for high functionality of μ-MIM Ti products.

信息:

期刊:

主题:

编辑:

T. Chandra, K. Tsuzaki, M. Militzer , C. Ravindran

页数:

3667-3672

引用:

H. Miura et al., "Micro Metal Injection Molding Process for High Performance Titanium Alloy", Materials Science Forum, Vols. 539-543, pp. 3667-3672, 2007

上线时间:

March 2007

输出:

价格:

$38.00

[1] S. Rath, L. Merz, V. Piotter, R. Ruprecht and J. Hausselt, Feedstocks and microparts made by powder injection molding, Proceedings of the 2003 International conference on Powder Metallurgy & Particulate Materials, 8-45-51, (2003).

DOI: https://doi.org/10.4028/www.scientific.net/msf.426-432.4227

[2] T. Gietzelt, O. Jacobi, V. Piotter, R. Ruprechet and J. Hausselt, Development and characterization of micro parts made by PIM, Proceedings of the 2003 International conference on Powder Metallurgy & Particulate Materials, 8-160-171, (2003).

[3] K. Nishiyabu, S. Matsuzaki, S. Tanaka and V. Piotter, Micro evaluation methodology for micro metal injection molding, Proceedings of the 2003 International conference on Powder Metallurgy & Particulate Materials, 8-172-189, (2003).

[4] T. Osada, K. Nishiyabu, S. Tanaka, H. Miura, Effect of Mixing Condition on Feedstock Properties for Micro Size Parts by MIM, Proceedings of the 2003 International Conference on Powder Metallurgy & Particulate Materials, (2003).

[5] T. Osada, K. Nishiyabu, A. Yuzuki, K. Okubo, S. Tanaka and H. Miura, Micro injection molding techniques for quality improvement of µ-MIM products, PM2004, 2004. Dj.M. Maric, P.F. Meier and S.K. Estreicher: Mater. Sci. Forum Vol. 83-87 (1992).