通过关键词查论文: Grain Boundary

文章题目页数

作者: Emilie Ferrié, Jean Yves Buffière, Wolfgang Ludwig
摘要: In-situ fatigue tests monitored by Synchrotron Radiation X-ray microtomography were carried out in order to visualize the three dimensional (3D) shape and evolution of short cracks in the bulk of a cast Al alloy. After the in-situ fatigue test the sample has been infiltrated with liquid Gallium (Ga) in order to visualize the grain structure of the material. Irregularities of the crack advance along the crack front can clearly be correlated to the grain structure of the material.
227
作者: T.V. Zaporozhets, I.V. Sobchenko, Andriy Gusak
摘要: The 3D Monte Carlo scheme is proposed for simulation of simultaneous self-consistent current redistribution, surface diffusion, drift and void migration and coalescence at the interface metal/dielectric. Results of simulation as well as simple phenomenological model demonstrate a possibility of trapping at and migration along the grainboundaries (GBs). Critical size of “detrapping” after coalescence has been estimated.
1306
作者: Rabab Khalid Sendi, Shahrom Mahmud, Amna Sirelkhatim
摘要: Zinc oxide-based varistors are semiconductor ceramics. Their excellent nonlinear electrical behaviors are induced from their grain boundaries and depend on their microstructural characteristics. From a theoretical aspect, finer primary particles with narrow size distributions provide better electrical and optical properties. Thus, these properties are related to the morphology and size of ZnO grains. In this study, ZnO-Bi2O3-Mn2O3 varistors fabricated from ZnO micro-and nanoparticle powders are prepared via conventional ceramic processing. The effects of ZnO particle size and different annealing ambients on the properties of ZnO varistors are also investigated. The strong solid-state reaction during sintering may be attributed to the high surface area of the 20 nm ZnO nanoparticles that promote strong surface reaction. The annealing process also improves grain crystallinity, as shown in the decrease in intrinsic compressive stress based on the X-ray diffraction lattice constant and full-width at half-maximum (FWHM) data. The reduced particle size significantly influences the electrical properties, showing a sharp drop in the breakdown voltage. Thus, the ZnO nanoparticles can be used to manufacture of varistors with superior properties and lower breakdown voltage compared with commercial ones.
428
作者: Valeri I. Orlov, Olga V. Feklisova, Eugene B. Yakimov
摘要: A comparative study of multicrystalline Si based solar cells and plastically deformed single crystalline Si by the EBIC, LBIC and XBIC methods as well as a computer simulation were carried out. The XBIC measurements were realized on a laboratory X-ray source. Simulations of LBIC and XBIC contrast values for grain boundaries, dislocations and spherical precipitates were carried out for different diffusion length and beam diameter values. It is shown by a computer simulation that the LBIC and XBIC contrast of two-dimensional defects in the crystals with a large enough diffusion length can be a few times higher than that in the EBIC mode, i.e. these methods in recent multicrystalline Si structures allow to reveal grain boundaries with the lower recombination strength. The contrast of dislocations perpendicular to the surface can be comparable in all three methods. The XBIC and LBIC contrast of precipitates usually is essentially smaller than that in the EBIC mode and could approach it in the structures with the small diffusion length only. Experimental data confirming the results of simulations are presented.
142
作者: Ke Tong, Fei Ye, Ya Kun Wang, Feng Zhou
摘要: The preferential sites for vacancies on a series of symmetric tilt grain boundaries in copper have been investigated by molecular dynamics simulation. The regularity of preferential sites for vacancies on these boundaries can be described by the structural unit model. This is essential because of the correspondence between the geometries of the structural units and the local stress field. The vacancies are energetically preferred at the sites with relatively large tensile stress, and these sites are the corner sites of the structural units. Moreover, these preferential sites are mainly related to the structural unit types irrespective of which grain boundary that the structure units locate in. Therefore, the preferential sites for vacancies on various grain boundaries formed by combinations of certain structural units can be readily described and predicted by the structural unit model.
1351
作者: X. Zhou, G.D. Watkins, K.M. McNamara Rutledge
825
显示842个文章标题中的1到10个